Directions for Use:
Take the microfibre heads (sold separately) and attach it to the frame with the hook and loop fitting.
Unscrew the cap from the pole. A colour coded ring can then be slipped onto the end of the handle at this stage if required.
Fill the pole with 480ml of water only to the level indicated by the top of the metal rod located inside the pole. Replace the cap securely by screwing into position. Do not use boiling water.
At the starting point place the mophead flat on the floor with the spray jets facing to the front or back depending on your preference, you can tell where the spray jets are by looking for the arrows on the system. Then press down on the thumb operated button on the top of the pole and three jets will spray water onto the floor.
Now move the mophead over the wet area evenly, lifting dirt and dust as you go. After, flip the mop and dry with the drying head. Repeat the process until the head becomes saturated or the system requires re-filling.
Dimensions - Handle Length: 145cm.